Official forums for BZFlag.org

I installed BZFlag in Linux Mint xcfe/Hardy Heron.
When I launch I get:
X Error of failed request: BadValue (integer parameter out of range for operation)
Major opcode of failed request: 134 (XFree86-VidModeExtension)
Minor opcode of failed request: 10 (XF86VidModeSwitchToMode)
Value in failed request: 0x63
Serial number of failed request: 149
Current serial number in output stream: 151
I opened it windowed and then chaged the resolution and that seemed to work, but the setting won't save. I am having to set this every time.

Is there a way to set the resolution permanently to the desired resolution that works? The save option in the game did nothing. Is there a config file where the resolution can be edited ,manually? If so where?

The config file is located at: ~/.bzf/2.0/config.cfg

You should look for something like in the config file. Obviously you are likely to use a different resolution..so replace the numbers with something you like, x is the seperator.

A friend of me had a similar problem a few days ago, too.

I have mint 6 installed now and can't find the config file. is it somewhere new in 2.0.10.20071115?

The configuration file is created by BZFlag, and on linux, it gets stored in ~/.bzf/2.0/config.cfg as it always has. Are you getting some error? (What exactly is leading you to believe it can't find the config?) You could also try deleting your existing ~/.bzf/ directory if one exists.

blast wrote:The configuration file is created by BZFlag, and on linux, it gets stored in ~/.bzf/2.0/config.cfg as it always has. Are you getting some error? (What exactly is leading you to believe it can't find the config?) You could also try deleting your existing ~/.bzf/ directory if one exists.

The problem was that the /.bzf/2.0/config.cfg file was not created at installation by Synaptic. the folder was not even there. The .bzf directory was in my home folder, but not the /2.0 sub directory. I uninstalled and then reinstalled BZFLAG, and the folder and config file were created. I was then able to set the resolution, which is always a problem on this system. My other PC never has a resolution problem, but this one does. Long story short - problem solved. Thanks for the help.

run bzflag -window -geometry 800x600 to get it to start the first time, then set your resolution.

your video driver is not reporting valid configurations for us to pick up on.